Test equipment and accessories
...................................................................................................................................................................................................................................
To be able to perform the tests described in this chapter, the following test equipment
and accessories are required:
1643 AM/AMS main unit
No DDF With DDF
ITM-CIT cable X X
PDH analyzer X
Measuring cables (E1 120 Ω UTP or 75 Ω coax depending on
the configuration)
X
Two single mode fibers with applicable connectors X
Optical attenuator, single mode, 1310/1550 nm X
Cleaning set for optical fibers X
If the 1643 AM/AMS has an option card installed, then the following test equipment
and accessories are required per option card:
1643 AM/AMS with an option card
Option cards
Accessories E1 E3 DS1 DS3 STM-1
Optical
X.21 Trans
LAN
X12
SHDSL
1x single mode fiber, 1x
10 dB attenuator for long
haul laser (L11, L12, L41,
or L42)
XXXX
2x single mode fibers, 2x
10 dB attenuator for long
haul laser (L11, L12, L41,
or L42)
XX
PDH BER test set with E1
option
XXX
2x E1 cables X
PDH BER test set with E3
option
X
2x E3 cables X
PDH BER test set with
DS1 option
X
2x DS1 cables,
refer to note 1
X
Stand-alone test procedures
...................................................................................................................................................................................................................................
365-312-802R7.2
Issue 4, June 2007
Alcatel-Lucent - Proprietary
See notice on first page
7-3
To Next Page
Loading...
