1643 AM/AMS with an option card
Option cards
Accessories E1 E3 DS1 DS3 STM-1
Optical
X.21 Trans
LAN
X12
SHDSL
PDH BER test set with
DS3 option
X
2x DS3 cable,
refer to note 1
X
2x single mode fibers,
refer to note 2
X
X.21 loop connector,
refer to note 3 and 4
X
1x Ethernet CAT 5 crossed
UTP cable
X
1x SHDSL cable
(see chapter 4, section
“SHDSL interfaces
(X12SHDSL-V2 card)”
(p. 4-37))
X
SHDSL E1 modem X
Note 1:
Since the pulse shape for DS1 and DS3 signals is defined at the DDF, the cable length
between the port and the DDF must be compensated for each port output (Menu: Port
Provisioning, Cable length). By default the cable compensation is set to 0-131 feet
(DS1) or 0-120 feet (DS3). Because the PDH analyzer is connected close to the DDF,
the receiver will deal with the cable loss. However for each port the length between
port and DDF should be estimated and compensated by selecting the proper length
range before the other side is connected.
Note 2:
For TM configurations (S4.1 and L4.1) an SDH analyzer is required (refer to the
remarks of the optical STM-1 option card test).
Note 3:
Stand-alone test procedures
Test equipment and accessories
...................................................................................................................................................................................................................................
7-4
Alcatel-Lucent - Proprietary
See notice on first page
365-312-802R7.2
Issue 4, June 2007
To Next Page
Loading...
