Alcatel-Lucent 1643 AMS - Page 207

Procedure
Proceed as follows to perform the optical STM-1 option card test:
...................................................................................................................................................................................................
1
Assign the installed option card.
...................................................................................................................................................................................................
2
Change the default Alarm Reporting/Severity of the STM1cNES (STM-1 Not Expected
Input Signal) alarm from reported “No” to “
Yes”.
...................................................................................................................................................................................................
3
Provision the following cross-connections:
Result:
Port under test Required cross-connections
TP2.1 TP2.1 – LP2.1,1
CC1,1.111 – TP1.1
CC1,1 – LP1.1,1
TP2.2 TP2.2 – LP1.1,2
CC1,2.111 – TP1.2
CC1,2 – LP2.1,2
...................................................................................................................................................................................................
4
Set the PDH analyzer to 2 Mbit/s, 2
15–1
PRBS pattern. Connect the analyzer to TP1.1.
...................................................................................................................................................................................................
5
Monitor the analyzer for correct transmission.
...................................................................................................................................................................................................
6
Connect the PDH analyzer to TP1.2.
...................................................................................................................................................................................................
7
Monitor the analyzer for correct transmission.
...................................................................................................................................................................................................
8
Display the raised alarm list on the ITM-CIT, and verify that the requirements
mentioned in the table below are met.
Result:
Requirements
LEDs on the 1643 AM:
Power: On
Stand-alone test procedures Optical STM-1 option card test
...................................................................................................................................................................................................................................
365-312-802R7.2
Issue 4, June 2007
Alcatel-Lucent - Proprietary
See notice on first page
7-17