Alcatel-Lucent 1643 AMS - View or edit MDO information

Conclusion: If the Fault LED is OFF, then the option card is accepted and the
option card software is correctly loaded. If the Link LED comes on and the alarms
are reported, then the option card is correctly installed.
...................................................................................................................................................................................................
5
If a DDF is applicable, then proceed with Step 6. If no DDF is applicable, then
proceed with Step 11.
...................................................................................................................................................................................................
6
Connect LAN2.1 to LAN2.3.
...................................................................................................................................................................................................
7
Check on the alarm list, and verify that the requirements mentioned in the table below
are met.
Result:
Requirements
Link LEDs of related LAN ports: On (green)
Alarms reported on the ITM-CIT: “LANcNES” reported on LAN2.1 and
LAN2.3
Conclusion: Results of Step 4 and Step 7 prove that the DDF labeling of LAN2.1,
LAN2.2, and LAN2.3 is correct.
...................................................................................................................................................................................................
8
Connect LAN2.1 to the next LAN port.
...................................................................................................................................................................................................
9
Check on the alarm list, and verify that the requirements mentioned in the table below
are met.
Result:
Requirements
Link LEDs of related LAN ports: On (green)
Alarms reported on the ITM-CIT: “LANcNES” reported on related LAN
...................................................................................................................................................................................................
10
Repeat Step 8 and Step 9 for all other LAN ports.
...................................................................................................................................................................................................
11
Disconnect the LAN cable from the LAN ports. Wait until all LANcNES alarms have
cleared.
...................................................................................................................................................................................................
12
Verify that the requirements mentioned in the table below are met.
Stand-alone test procedures X4IP, X8PL, and X5IP option card test
...................................................................................................................................................................................................................................
365-312-802R7.2
Issue 4, June 2007
Alcatel-Lucent - Proprietary
See notice on first page
7-23