Installation of an option card
...................................................................................................................................................................................................................................
Overview
This section provides a procedure for upgrading the 1643 AMS with one of the option
cards. An overview about all available option cards is given in chapter 2, section
“Upgrade with option cards” (p. 2-7).
Before you begin
Please read section “Option card and SFP handling” (p. 2-12) before performing the
procedure described below.
Procedure
Proceed as follows to mount an option card:
...................................................................................................................................................................................................
1
Remove the top cover.
...................................................................................................................................................................................................
2
Remove the dummy panel fixed on the front.
...................................................................................................................................................................................................
3
Insert the option card (item 1) into P1 and/or P2 connectors. Make sure the connectors
are properly engaged and seated.
Important! Fit the X5IP option card by inserting at an angle the faceplate of the
card to the back of the AMS faceplate. Gently push the card towards the AMS
faceplate to slowly move the connectors into position.
...................................................................................................................................................................................................
4
Secure the option card with seven M3x6 screws as shown in Figure 3-15, “Installation
of an AMS option card” (p. 3-22).
...................................................................................................................................................................................................
5
Align and stick the function label delivered with the option card on the front plate.
...................................................................................................................................................................................................
6
IF ... THEN ...
an X16E1-V3, X16DS1 or
X12SHDSL-V2 option card has
been installed,
proceed with section “Mounting the EMC bracket”
(p. 3-23).
any other option card type has
been installed,
reinstall the top cover.
Mechanical installation
...................................................................................................................................................................................................................................
365-312-802R7.2
Issue 4, June 2007
Alcatel-Lucent - Proprietary
See notice on first page
3-21
E ND OF STEPS
...................................................................................................................................................................................................
To Next Page
Loading...
