LANRFI (Remote Fault Indication)
An LANRFI condition may be raised on a client or network port of a transponder card
and may be attributed to a fault on the remote device (the equipment connected to the
client or network port). The remote device is either detecting a problem on its receive link
or has some sort of local fault and is generating an LANRFI in the downstream direction.
Severity Not reported
Service affecting? No
Applicability 112SA1L, 112SCA1, 112SCX10, 112SX10L, 11DPE12,
11DPE12E, 11QPA4, 43SCX4, 43STX4
Corrective Action
NOTICE
Service-disruption hazard
A cold reset, reseat, or replacement of a card is service impacting if the card is currently
carrying services. To determine if any services are currently carried over a card, perform
the procedure “Reseating a Card” (p. 3-19).
If
there are services currently carried over the card, it may be best to wait for a
maintenance window before resetting, replacing, or reseating the card.
At the end of each step wait to see if the fault clears. If not, continue with the next step.
...................................................................................................................................................................................................
1
Retrieve alarms and conditions for the local node that has the RFI condition on its receive
port. Examine them and identify faults on the services supporting the devices that have
the RFI condition. Resolve any issues with respect to these faults first.
...................................................................................................................................................................................................
2
Repeat Step 1 for the far end device. Examine the devices associated with the same
services as in Step 1.
...................................................................................................................................................................................................
3
Perform a warm reset on the local card where the LANRFI condition is raised.
CLI config card card type shelf slot reset warm
WEBUI Select the card, click the Reboot tab, select Warm Reboot >Submit.
Trouble-clearing procedures
LANRFI
LANRFI (Remote Fault Indication)
....................................................................................................................................................................................................................................
....................................................................................................................................................................................................................................
2-124
1830 PSS-36/PSS–32/PSS-16/PSS-4
8DG60888CAAA Release 3.6.0 and 3.6.1
Issue 1 June 2011
To Next Page
Loading...
