...................................................................................................................................................................................................
4
Replace the User Panel and make all connections as described in the Alcatel-Lucent 1830
Photonic Service Switch Release 36/32/16 (PSS-36/PSS-32/PSS-16) 3.6.0 Installation and
System Turn-up Guide.
...................................................................................................................................................................................................
5
If... Then...
the NE automatically reboots perform the steps in the procedure,
“DBINVALID” (p. 2-64), then continue with
Step 6.
T
o preserve traffic during an NE reboot, the
NE's database should NOT be initialized. After
the reboot, a previously backed up database
should be restored to the NE.
the NE does not automatically reboot continue with Step 6.
...................................................................................................................................................................................................
6
To synchronize the database and new User Panel, type
config database usrpnlrepl
Note: Older versions of the database, can only be restored onto the NE by adding the
word “force“ to the CLI command. For example:
config database restore force
...................................................................................................................................................................................................
7
Type config database restore.
...................................................................................................................................................................................................
8
Backup the database again, now that the User Panel is successfully replaced.
Replacing the User Panel Interrupted By NE Restart
If a User Panel is replaced on an NE, but before the user has a chance to successfully
complete the
config database usrpnlrepl command, the NE restarts, then the NE
may check the new User Panel contents and not see that it has been commissioned. To
preserve traffic during the NE restart, do not reinitialize the NE database. Instead, restore
a previously backed up database to the NE after the restart.
Supporting procedures
Replacing System Components
Replacing the User Panel
....................................................................................................................................................................................................................................
....................................................................................................................................................................................................................................
1830 PSS-36/PSS–32/PSS-16/PSS-4
8DG60888CAAA Release 3.6.0 and 3.6.1
Issue 1 June 2011
3-37
E ND OF STEPS
...................................................................................................................................................................................................
To Next Page
Loading...
