Alcatel-Lucent 7210 SAS M - Page 207

Virtual Leased Line Services
7210 SAS M Services Guide Page 207
Epipe Spoke SDP Configuration Commands
Note: Spoke SDP commands are not supported on 7210 SAS-M devices configured in Access
Uplink mode.
config
—service
— epipe service-id [customer customer-id] [create] [vpn vpn-id](for 7210 SAS-M in Network
mode)
— epipe service-id [customer customer-id] [create] [vpn vpn-id][customer customer-id] [cre-
ate] [vpn vpn-id] [svc-sap-type {null-star|dot1q|dot1q-preserve|any}] [customer-vid vlan-
id] (for 7210 SAS-M in Access uplink mode)
— spoke-sdp sdp-id[:vc-id] [vc-type {ether | vlan}] [create] [no-endpoint]
— spoke-sdp sdp-id[:vc-id] [vc-type {ether | vlan}] [create] endpoint
—no spoke-sdp sdp-id[:vc-id]
— accounting-policy acct-policy-id
—no accounting-policy
— [no] collect-stats
— [no] control-word
— [no] description
— [no] egress
— [no] vc-label egress-vc-label
— mep
— mep mep-id domain md-index association ma-index [direction
{up | down}]
—no mep mep-id domain md-index association ma-index
— ais-enable
—no ais-enable
— client-meg-level [level [level ...]]
— no client-meg-level
— [no] ccm-enable
— ccm-ltm-priority priority
—no ccm-ltm-priority
— [no] description
— [no] eth-test-enable
— bit-error-threshold bit-errors
— no test-pattern
— test-pattern {all-zeros|all-ones} [crc-enable]
— interval {1|60}
—no interval
—no
priority
— priority priority-value
— low-priority-defect {allDe f |macRemErrXcon |
remErrXcon | errXcon | xcon | noXcon}
— mac-address mac-address
— no mac-address
— [no] shutdown
—[no] force-vlan-vc-forwarding
— [no] ingress
— [no] vc-label egress-vc-label
— precedence [precedence-value| primary]
—no precedence
— [no] shutdown
— vlan-vc-tag 0..4094