Alcatel-Lucent 7210 SAS M - Page 903

VPLS Show Commands
7210 SAS M Services Guide Page 903
Sample Output
A:Dut-A>show>service>id# sdp 1217:305
===============================================================================
Service Destination Point (Sdp Id : 1217:305)
===============================================================================
SdpId Type IP address Adm Opr I.Lbl E.Lbl
-------------------------------------------------------------------------------
1217:305 Spok 10.20.1.2 Up Up 130506 130516
Label Description
Sdp Id
The SDP identifier.
Type
Indicates whether the SDP is spoke.
VC Type
Displays the VC type: ether, vlan, or vpls.
VC Tag
Displays the explicit dot1Q value used when encapsulating to the SDP
far end.
I. Lbl
The VC label used by the far-end device to send packets to this device
in this service by the SDP.
Admin Path MTU
The operating path MTU of the SDP is equal to the admin path MTU
(when one is set) or the dynamically computed tunnel MTU, when no
admin path MTU is set (the default case.)
Oper Path MTU
The actual largest service frame size (in octets) that can be transmitted
through this SDP to the far-end router, without requiring the packet to
be fragmented.
Far End
Specifies the IP address of the remote end of the GRE or MPLS tunnel
defined by this SDP.
Delivery
Specifies the type of delivery used by the SDP: GRE or MPLS.
Admin State
The administrative state of this SDP.
Oper State
The current status of the SDP.
Ingress Label
The label used by the far-end device to send packets to this device in
this service by this SDP.
Egress Label
The label used by this device to send packets to the far-end device in
this service by the SDP.
Last Changed
The date and time of the most recent change to the SDP.
Signaling
Specifies the signaling protocol used to obtain the ingress and egress
labels used in frames transmitted and received on this SDP.
Admin State
The administrative state of the Keepalive process.
Oper State
The operational state of the Keepalive process.