Page 142 7450 ESS OS Basic System Configuration Guide
neighbor
Syntax neighbor neighbor [neighbor...(up to 5 max)] [interval seconds] [repeat repeat] [absolute | rate]
Context monitor>router>rip
Description This command displays statistical RIP neighbor information at the configured interval until the configured
count is reached.
The first screen displays the current statistics related to the specified RIP neighbor(s). The subsequent
statistical information listed for each interval is displayed as a delta to the previous display. When the
keyword rate is specified, the "rate per second" for each statistic is displayed instead of the delta.
Monitor commands are similar to show commands but only statistical information displays. Monitor
commands display the selected statistics according to the configured number of times at the interval
specified.
Parameters neighbor ip-address — The IP address to display information for entries received from the specified RIP
neighbor. Up to 5 IP addresses can be displayed.
interval seconds — Configures the interval for each display in seconds.
Default 5 seconds
Values 3 — 60
repeat repeat — Configures how many times the command is repeated.
Default 10
Values 1 — 999
absolute — When the absolute keyword is specified, the raw statistics are displayed, without processing.
No calculations are performed on the delta or rate statistics.
rate — When the rate keyword is specified, the rate-per-second for each statistic is displayed instead of the
delta.
interface
Syntax interface interface [interface...(up to 5 max)][interval seconds] [repeat repeat] [absolute | rate]
Context monitor>router>rsvp
Description This command displays statistics for RSVP interfaces at the configured interval until the configured count is
reached.
The first screen displays the current statistics related to the RSVP interface(s). The subsequent statistical
information listed for each interval is displayed as a delta to the previous display. When the keyword rate is
specified, the "rate per second" for each statistic is displayed instead of the delta.
Monitor commands are similar to show commands but only statistical information displays. Monitor
commands display the selected statistics according to the configured number of times at the interval
specified.
To Next Page
Loading...
