Show Commands
7450 ESS OS Basic System Configuration Guide Page 441
Steps Removed : 1 Parent Clock : no
Tx Timestamp Point: port Rx Timestamp Point : port
Last Tx Port : 3/2/1 Last Rx Port : 3/2/1
===============================================================================
sntp
Syntax sntp
Context show>system
Description This command displays SNTP protocol configuration and state.
Output Show SNTP Output — The following table describes SNTP output fields.
Sample Output
A:ALA-1# show system sntp
===============================================================================
SNTP
===============================================================================
SNTP Server Version Preference Interval
-------------------------------------------------------------------------------
10.10.20.253 3 Preferred 64
===============================================================================
A:ALA-1#
thresholds
Syntax thresholds
Context show>system
Description This command display system monitoring thresholds. The “Threshold Events Log” table will keep only the
last 201 entries.
Table 28: Show System SNTP Output Fields
Label Description
SNTP Server
The SNTP server address for SNTP unicast client mode.
Version
The SNTP version number, expressed as an integer.
Preference
Normal — When more than one time server is configured, one
server can be configured to have preference over another.
Preferred — Indicates that this server has preference over another.
Interval
The frequency, in seconds, that the server is queried.
To Next Page
Loading...
