Alcatel-Lucent 7450 ESS-12 - Page 507

Show Commands
7450 ESS OS Basic System Configuration Guide Page 469
Sample Output
A:ALA-48>show>redundancy# synchronization
===============================================================================
Synchronization Information
===============================================================================
Standby Status : disabled
Last Standby Failure : N/A
Standby Up Time : N/A
Failover Time : N/A
Failover Reason : N/A
Boot/Config Sync Mode : None
Boot/Config Sync Status : No synchronization
Last Config File Sync Time : Never
Last Boot Env Sync Time : Never
===============================================================================
A:ALA-48>show>redundancy#
time-range
Syntax time-range name associations [detail]
Context show>cron
Description This command displays information on the configured time ranges.
Output Time Range Output — The following table displays system time range output fields:
Sample Output
The following example shows time-range detail output.
A:ala# show cron time-range time-range2 detail
===============================================================================
Cron time-range
===============================================================================
Name : time-range1
Periodic : Start * * * * End * * * *
Absolute : Start * * * * End * * * *
The following example shows output for time-range associations with previously created IP and MAC fil-
ters.
A:ala# show cron time-range day associations
Table 33: Show System Time-range Output Fields
Label Description
Associations
Shows the time-range as it is associated with the TOD suites and ACL
entries as well as the SAPs using them.
Detail
Shows the details of this time-range.