Establishing Connections
Page 90 7450 ESS-7
ESTABLISHING CONNECTIONS
Access the newly installed switch two ways:
• Console Connection on page 90
• Telnet Connection on page 92
CONSOLE CONNECTION
To establish a console connection, you will need the following:
• An ASCII terminal or a PC running terminal emulation software set to the parameters
shown in the table below.
• A standard serial cable with a female DB9 connector.
For pinout information, refer to Appendix C: Pinout Assignments on page 153.
Table 30: Console Configuration Parameter Values
Parameter Value
Baud Rate 115,200
Data Bits 8
Parity None
Stop Bits 1
Flow Control None
To Next Page
Loading...
