Enhanced Subscriber Management (ESM) Accounting
Page 166 7750 SR RADIUS Attributes Reference Guide
26-6527-121 Alc-Nat-Port-Range Holds for the NAT user his public outside ipv4 address, his assigned outside
public port range(s) and the outside routing instance. For LSN accounting, the
attribute is sent when port-range-block is included under configure aaa isa-
radius-policy.
The attribute is also sent for ESM subscriber accounting if NAT is enabled
and if configured in configure subscriber-mgmt radius-accounting-policy
<name> include-radius-attribute nat-port-range.
2 6 - 6 5 2 7 - 1 2 7 A l c - A c c t - O - s t a t m o d e I d e n t i f i e s w h a t egress counters the operator wishes to maintain for the policer
and defined by configure qos sap-egress <policy-id> policer <policer-id>
stat-mode <stat-mode>. The default stat-mode is minimal and the current
stats-modes are: no-stats, minimal, offered-profile-no-cir, offered-profile-cir,
offered-total-cir, offered-limited-capped-cir and offered-profile-capped-cir
For both policers and queues, the egress stat-mode can be configured to v4-v6
at the sla-profile or sub-profile (hsmda queues only) CLI context. For
example: configure subscriber-mgmt sla-profile <sla-profile-name> egress
qos <policy-id> queue <queue-id> stat-mode v4-v6
With egress stat-mode v4-v6:
• Egress forwarded/dropped counters are reporting IPv4 counters in the in-
profile attributes and IPv6 counters in the out-of-profile attributes.
• The Alc-Acct-O-statmode VSA is included with value v4-v6 for both
queues and/or policers.
26-6527-140 Alc-Nat-Outside-Serv-
Id
DSM Only. For a DSM UE this attribute includes the service ID of the outside
VRF where IPv4 traffic will be forwarded after NAT.
26-6527-141 Alc-Nat-Outside-Ip-
Addr
DSM Only. For a DSM UE this attribute contains the IPv4 address of the UE
after NAT.
26-6527-148 Alc-RSSI Received Signal Strength Indication. Used in conjunction with the radius-
proxy track-accounting feature. When the radius-proxy receives this attribute
in an accounting message, it will be copied into the DHCP lease state and
echoed by the SROS accounting.
26-6527-163 Alc-Acct-Triggered-
Reason
A reason attribute included in Acct-Interim messages to specify the reason for
the interim update. Attribute is omitted in accounting via configure
subscriber-mgmt radius-accounting-policy <name> include-radius-
attribute no alc-acct-triggered-reason.
26-6527-175 Alc-DSL-Line-State Status of the DSL line obtained via ANCP can be one of three value:
SHOWTIME (the modem is ready to transfer data), IDLE (line is idle) or
SILENT (line is silent). Attribute is included/excluded based on "configure
subscriber-mgmt authentication-policy/radius-accounting-policy <name>
include-radius-attribute access-loop-options".
Table 52: Enhanced Subscriber Management Accounting (description) (Continued)
Attribute ID Attribute Name Description
To Next Page
Loading...
