3- Connect the handset with the deskphone
• Searching for Bluetooth® equipment. Wait for the detected equipment type and address to be
displayed.
• Select the Bluetooth® wireless handset displayed in your deskphone: “ALE BT WB Handset”.
• Add the device by selecting the relevant menu on your deskphone (Depending on the
deskphone).
• If voice prompts are enabled, you hear: “Device connected”. The 3-note tone indicates that the
handset has been installed correctly. The LED flashes blue or red depending on the battery
charge level.
The handset is correctly connected if it appears in the list of connected devices on your deskphone (see
user manual of the deskphone). Press the Line key of the handset to test the connection, your
deskphone prompts you to enter a number. Please contact your installer if you encounter any problems.
Before contacting your installer make sure you have information such as the serial number, the date
code and the technical reference that you can find on the battery.
1.14 ALE Bluetooth® Handset
The Bluetooth® Wireless handset is only available with compatible Bluetooth® deskphones.
Switch on / off the Bluetooth® handset: long press on the
off-hook/on-hook key.
Off-hook/On-hook: press this key to take or terminate a call.
• Short successive
presses to change
the handset volume
level (3 levels)
• Long press to
activate or
deactivate mute
mode
If the Bluetooth® handset is on its base, you do not need to press the Off-hook/On-hook key to take or
terminate the call. Just off-hook/on-hook the Bluetooth® handset.
1.14.1 LED
• Off: operating normally.
• Green flashing: in communication.
• Green steady: handset charging.
• Orange flashing: battery charge low or handset outside coverage zone.
• Orange steady: malfunction.
If the Bluetooth® handset is on its base, you do not need to press the Off-hook/On-hook key to take or
terminate the call. Just off-hook/on-hook the Bluetooth® handset.
To Next Page
Loading...
