3EM23953AB
Issue 01, February 2010
Unpack and Inspect Equipment
1-1
Chart-1
Charts
Chart-1
Unpack and Inspect Equipment
PURPOSE
This chart provides instructions to unpack and inspect the 9500 MPR radio and to report any
shipping damage or missing parts.
GENERAL
The 9500 MPR radio may be shipped from the factory as an assembled rack assembly or as kits for
field installation.
Alcatel-Lucent provides expert Installation Services for installations that have different
requirements from the recommended configuration as outlined in this manual. Contact the
Alcatel-Lucent Technical Support Center at 1-(888) 252-2832 for details.
RECOMMENDED TOOLS
• Tin snips
• Box cutter
STEP PROCEDURE
1 DANGER: Possibility of personal injury. The 9500 MPR radio requires two people to
unpack a factory assembled rack assembly from the box. To prevent equipment
damage or personal injury, make sure appropriate help or suitable lifting equipment
is available if needed.
2 WARNING: Possibility of equipment damage. If product must be transported
or reshipped, repack equipment with approved shipping materials.
Repacking equipment improperly or using unapproved shipping materials
may result in equipment damage, which is sender’s responsibility. If any
shipping materials are lost, contact Alcatel-Lucent before transporting or
reshipping product.
3 Remove external packing slip from shipping container.
4 Before unpacking container, ensure there is no visible damage to outside of container.
If damage is visible, report damage to freight carrier before opening container. Freight
carrier will advise as to next step to take. (If a camera is available, take several
pictures of damage.)
5 Use tin snips to cut container strapping.
To Next Page
Loading...
