Alcatel-Lucent Halo H6 - Page 81

Copyright @ALE 2020 All Rights Reserved
81
Description
It configures the no answer forward on code to activate the server-side no answer
forward feature.
The IP phone will send the no answer forward on code and the pre-configured destination
number (configured by the parameter “ForwardNoReplyDest”) to the server when you
activate no answer forward feature on a phone basis.
Example:
ForwardNoReplyOnCode = *52
Note: If default account is account 2 and the value of the parameter
“ForwardModeAccount” is phone to 0 (Phone).
Permitted
Values
String within 32 characters
Default
Black
Web UI
Features -> Forward->On Code(under No Reply FWD)
Phone UI
Menu->Features->Call Forward->No Answer Forward->On Code
Parameter
ForwardNoReplyOffCode
config.<mac>.xml
Description
It configures the no answer forward off code to deactivate the server-side no answer
forward feature. The IP phone will send the no answer forward off code to the server
when you deactivate no answer forward feature on the IP phone.
Example:
ForwardNoReplyOffCode = *53
Note: If default account is account 2 and the value of the parameter
“ForwardModeAccount” is phone to 0 (Phone).
Permitted
Values
String within 32 characters
Default
Black
Web UI
Features -> Forward->Off Code(under No Reply FWD)
Phone UI
Menu->Features->Call Forward->No Reply Forward->Off Code
Parameter
SIPForwardDurationNoreply
config.<mac>.xml
Description
The incoming calls will be forwarded when not answered after M (M is configurable by
“SIPForwardDurationNoreply”) seconds.
Permitted
Values
Integer from 10 to 60
Default
10
Web UI
Features -> Forward -> Forward Duration Noreply(under No Reply FWD)
The following table lists the parameters you can use to configure call forward in Custom mode.
Parameter
ForwardImmStateX
H3P/H3G: X=1~3
H6: X=1~4
config.<mac>.xml
Description
It triggers the always forward feature to on or off on a phone basis.
Note: It works only if “ForwardModeAccount” is phone to 1 (Custom).
Permitted
Values
0-Off
1-On, incoming calls are forwarded to the destination number (configured by the
parameter “ForwardImmDestX”) immediately.
Default
0
Web UI
Features -> Forward->Immediate FWD->On/Off