Point to Point Protocol
Left running head:
Chapter name (automatic)
296
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
PPP IPCP ADDRESS ACCEPT-LOCAL
ppp ipcp address accept-local
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command is
entered in the Interface Configuration mode. This command sets a flag to accept
a local IP address given to it by the peer during IPCP.
PARAMETERS
None.
DEFAULT VALUE
By default, the flag is set to reject the local IP address from the peer during IPCP.
EXAMPLE
ALU(config-if Serial0/0:0)# ppp ipcp address accept-local
PPP IPCP ADDRESS ACCEPT-PEER
ppp ipcp address accept-peer
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command
sets the flag to accept the peer’s IP address during IPCP.
PARAMETERS
None.
DEFAULT VALUE
By default, the flag is set to accept the peer’s IP address during IPCP.
EXAMPLE
ALU(config-if Serial0/0:0)# ppp ipcp address accept-peer
To Next Page
Loading...
