Alcatel-Lucent OmniAccess 5740 - Ppp Timeout Max-Failure; Ppp Timeout Max-Terminate

ppp timeout max-failure
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
301
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
PPP TIMEOUT MAX-FAILURE
ppp timeout max-failure <1-30>
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command
sets the maximum number of configure NaK packets (LCP or NCP) sent without
sending a Configure Ack before assuming that configuration is not converging.
PARAMETERS
DEFAULT VALUE
The default max-failure value is “5”.
EXAMPLE
ALU(config-if Serial0/0:0)#ppp timeout max-failure 10
PPP TIMEOUT MAX-TERMINATE
ppp timeout max-terminate <1-30>
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command
sets the maximum number of terminate request packets (LCP or NCP) sent
without receiving a Terminate Ack, before assuming that the peer is unable to
respond.
PARAMETERS
DEFAULT VALUE
The default max-terminate value is “2”.
EXAMPLE
ALU(config-if Serial0/0:0)# ppp timeout max-terminate 10
Parameter Description
1-30 Maximum number of configure NaK packets
(LCP or NCP) to be sent without sending a
Configure Ack, before assuming that
configuration is not converging.
Parameter Description
1-30 The maximum number of terminate request
packets to be sent, before assuming that the
peer is unable to respond.