Point to Point Protocol
Left running head:
Chapter name (automatic)
302
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
SHOW INTERFACES
show interfaces <name>
DESCRIPTION
This command is entered in the Super User Mode or Configuration Mode.
Displays detailed statistics and other information for a specified interface.
PARAMETERS
EXAMPLE
The following example shows the states for LCP, CHAP Client, EAP Server, and
IPCP in the "show interfaces" output.
ALU(config-if Serial0/0:0)# show interfaces Serial 0/0:0
Serial0/0:0 is up, line protocol is up
Internet address is 100.101.102.103/24
MTU 1200 bytes, BW 1544 Kbit, DLY 0 usec,
reliability 0/255, txload 0/255, rxload 0/255
loopback not set
Encapsulation ppp, Keepalive set (10 sec)
LCP: Open
CHAP Client: Open
EAP Server: Open
IPCP: Open
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Queueing strategy: fifo
Output queue: 0/0 (size/max) 0 drops; Input queue: 0/0 (size/max) 0
drops
Conversations: 0/0/0/0 (active/max active/max total)
Reserved Conversations: 0/0 (allocated/max allocated)
Available Bandwidth 1544 kilobits/sec
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
50 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
60 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
Timeslot(s) Used:1-31, Transmitter delay is 0 flags
Parameter Description
name Name of the interface with the slot and port
numbers.
To Next Page
Loading...
