Point-to-Point Protocol over Ethernet (PPPoE)
Left running head:
Chapter name (automatic)
314
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
ENCAPSULATION PPPOE
encapsulation pppoe
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command
sets the PPPoE encapsulation on the Gigabit Ethernet interface. OmniAccess
5740 USG always acts as a PPPoE client.
PARAMETERS
None.
DEFAULT VALUE
None.
PLATFORMS SUPPORTED
OmniAccess 5740 USG
EXAMPLE
ALU(config)# interface GigabitEthernet3/0
ALU(config-if GigabitEthernet3/0)# encapsulation pppoe
RELEASE HISTORY
Release 2.3: command was introduced.
To Next Page
Loading...
