Bridging Configuration
Left running head:
Chapter name (automatic)
374
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
BRIDGING CONFIGURATION COMMANDS
This section deals with the commands related to configuring bridging on
OmniAccess 5740 USG:
CLEAR BRIDGE STATISTICS
clear bridge statistics
DESCRIPTION
This is entered in the Super User Mode or Configuration Mode. This command is
used to clear the bridge node statistics.
PARAMETERS
None.
PLATFORMS SUPPORTED
OmniAccess 5740 USG
EXAMPLE
ALU(config)# clear bridge statistics
RELEASE HISTORY
Release 3.0: command was introduced.
NO VLAN
no vlan {<2-4094>... |native|range <2-4094> <2-4094>}
This is entered in the Interface Configuration Mode. This command is used to
disable BCP if all VLANs are removed from the interface configuration.
Use ‘Native’ keyword to disable bridging of untagged packets. Native VLAN is no
more native though vlan is still configured on the interface. BCP will be disabled if
the last VLAN configuration is removed. This command is also used to delete
range of VLANs configured on the interface.
To Next Page
Loading...
