Open Shortest Path First
Left running head:
Chapter name (automatic)
590
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
SHOW IP OSPF INTERFACE
show ip ospf [<1-65535>] interface [{<interface-name>
|statistics [<interface-name>]}]
DESCRIPTION
This command is entered in the Super User Mode or Configuration Mode. This
command displays OSPF-related interface information.
PARAMETERS
EXAMPLE
EXAMPLE 1
ALU# show ip ospf interface
GigabitEthernet3/0 is up, line protocol is up
Internet Address 1.1.1.2/24, Area 0
Process ID 1, Router ID 1.1.1.2, Network Type BROADCAST, Cost: 1
Transmit Delay is 1 sec, State DR, Priority 1
Designated Router (ID) 1.1.1.2, Intf address 1.1.1.2
Backup Designated router (ID) 1.1.1.1, Intf address 1.1.1.1
Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5
Hello due in 00:00:03
Neighbor Count is 1, Adjacent neighbor count is 1
Adjacent with neighbor 1.1.1.1 (Backup Designated Router)
Suppress hello for 0 neighbor(s)
Message digest authentication enabled
GigabitEthernet3/1 is up, line protocol is up
Internet Address 2.2.2.2/24, Area 1
Process ID 1, Router ID 1.1.1.2, Network Type BROADCAST, Cost: 1
Transmit Delay is 1 sec, State BDR, Priority 1
Designated Router (ID) 6.6.6.6, Intf address 2.2.2.1
Backup Designated router (ID) 1.1.1.2, Intf address 2.2.2.2
Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5
Hello due in 00:00:03
Neighbor Count is 1, Adjacent neighbor count is 1
Adjacent with neighbor 6.6.6.6 (Designated Router)
Suppress hello for 0 neighbor(s)
ALU#
Parameter Description
1-65535 Process ID. If this argument is included,
only information for the specified routing
process is displayed.
interface-name Name of the interface name.
statistics Displays the OSPF statistics.
To Next Page
Loading...
