Alcatel-Lucent OmniAccess 5740 - Ip Igmp Join-Group; Ip Igmp Last-Member-Query-Count

ip igmp join-group
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
621
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
IP IGMP JOIN-GROUP
ip igmp join-group <group-address>
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command is
used to join specified multicast group.
PARAMETERS
DEFAULT VALUE
No group is joined by default.
EXAMPLE
ALU(config-if GigabitEthernet3/0)# ip igmp join-group 226.2.2.2
IP IGMP LAST-MEMBER-QUERY-COUNT
ip igmp last-member-query-count <1-7>
DESCRIPTION
This command is entered in the Interface Configuration Mode. Use this command
to configure the number of retransmission of group-specific queries.
PARAMETERS
DEFAULT VALUE
The default last-member-query-count is 2.
EXAMPLE
ALU(config-if GigabitEthernet3/0)# ip igmp last-member-query-
count 3
Parameter Description
group-address Address of the multicast group.
Parameter Description
1-7 Number of retransmission of group specific query. This is
also called as robustness count.