Alcatel-Lucent OmniAccess 5740 - Show Ip Protocols

show ip protocols
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
661
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
SHOW IP PROTOCOLS
show ip protocols [vrf <vrf-name>]
DESCRIPTION
This command is entered in the Super User Mode or Configuration Mode. This
command displays the routing protocol information associated with a VRF.
PARAMETERS
PLATFORMS SUPPORTED
OmniAccess 5740 USG
EXAMPLE
ALU(config)# show ip protocols vrf ALU-vrf
Routing Protocol is "ospf 1"
Invalid after 3600 seconds, hold down 5, flushed after 3600 seconds
Router Id 4.4.4.4
Number of Areas in this router 1. 1 normal 0stub 0 nssa
Outgoing update filter list for all interfaces is not set
Incoming update filter list for all interfaces is not set
Routing for Networks:
4.0.0.0/8
Routing Information Sources:
Gateway Distance Last Update
4.4.4.1 110 00:05:56
Distance: (default is 110)
Routing Protocol is "bgp 100"
IGP synchronization is enabled
Automatic route summarization is disabled
BGP Information for VRF: "ALU-vrf"
Incoming update filter list for all interfaces is not configured
Outgoing update filter list for all interfaces is not configured
Neighbor(s):
Address FiltIn FiltOut DistIn DistOut RmapIn RmapOut
Weight
4.4.4.1
Routing for Networks:
Routing Information Sources:
Gateway Distance Last Update
4.4.4.1 20 00:02:12
Distance: external 20 internal 200 local 200
RELEASE HISTORY
Release 2.3: command was introduced.
Parameter Description
vrf-name The name of the VRF for which the
protocol information is to be viewed.