Alcatel-Lucent OmniAccess 5740 - Source Nat (SNAT) Configuration Commands; Source-Nat

Network Address Translation
Left running head:
Chapter name (automatic)
672
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
SOURCE NAT (SNAT) CONFIGURATION COMMANDS
SOURCE
-NAT
[<1-65535>] match [{all|any}] <match-list name> source-nat
DESCRIPTION
This command is entered in the NAT Configuration Mode. This command is used
to configure a SNAT, and configure one or more rule (set priority for the rule,
associate match-lists and action) for the configured SNAT.
PARAMETERS
DEFAULT VALUE
None.
EXAMPLE
ALU(config-nat-N1)# 10 match m1 source-nat
Parameter Description
1-65535 The range for the NAT policy rule. This rule number
signifies the priority of a rule.
match [{all|any}]
<match-list name>
match all - In this type of match, the relevant action is
performed only when all the match-list criteria is
satisfied.
match any - In this type of match, the relevant action is
performed even if any one of the match-list criterion is
satisfied.
source-nat Type of NAT, here it is the SNAT.