Filter and Firewall
Left running head:
Chapter name (automatic)
724
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
NO POLICY
no policy <name> [force]
This command is entered in the Firewall Configuration Mode.The "force" keyword
will automatically detach the specified policy from respective interfaces, and
deletes the policy. This command can also be used to delete all the policy rules.
NO RULE
no rule <1-65535>
This command is entered in the Firewall Policy Sub Configuration Mode. This
deletes only the rule in the firewall policy corresponding to the line number.
POLICY
policy <name>
DESCRIPTION
This command is entered in the Firewall Configuration Mode. This command is
used to configure a firewall policy. This enters the firewall policy sub-configuration
mode
PARAMETERS
EXAMPLE
The following example depicts firewall policy configuration:
ALU(config-firewall)# policy P1
ALU(config-firewall-P1)#
Parameter Description
name Name of the firewall policy to be configured.
To Next Page
Loading...
