EasyManua.ls Logo

Alcatel-Lucent OmniSwitch 10K - Page 107

Alcatel-Lucent OmniSwitch 10K
148 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
OmniSwitch OS6860/OS6900/OS10K Troubleshooting Guide Part No.032996-00 Rev.A
AOS Release 7.X and 8.X January 2015
Alcatel-Lucent Page 107 of 148
Last Member Query Interval (tenths of seconds) = 10,
Unsolicited Report Interval (seconds) = 1,
Router Timeout (seconds) = 90,
Source Timeout (seconds) = 30,
Max-group = 0,
Max-group action = none,
Helper-address = 0.0.0.0,
Zero-based Query = enabled
Display querier information:
-> show ip multicast querier
Total 1 Queriers
Host Address VLAN Port Static Count Life
---------------+-----+---------+-------+------+-----
172.13.0.1 2107 1/1/1 no 28520 254
Display sources information:
-> show ip multicast source
Total 1 Sources
Group Address Host Address Tunnel Address VLAN Port
---------------+---------------+---------------+-----+---------
239.0.0.1 10.0.0.1 0.0.0.0 1 2/1/1
Display information related to receives:
-> show ip multicast group
Total 1 Groups
Group Address Source Address VLAN Port Mode Static Count Life
---------------+---------------+-----+---------+--------+-------+------+-----
239.0.0.1 0.0.0.0 1 1/1/48 exclude no 5 259
Display active flow information:
Warning:
Flow in this table are populated only in case there is a group match from the the group table and
the source table, there must be also an active querier in the network.
-> show ip multicast forward
Total 1 Forwards
Ingress Egress
Group Address Host Address Tunnel Address VLAN Port VLAN Port
---------------+---------------+---------------+-----+---------+-----+---------
239.0.0.1 10.0.0.1 0.0.0.0 1 2/1/1 1 1/1/48
Logging to SWLOG
Enabling detailed logging:
-> show configuration snapshot system
! System Service:
swlog appid ipmsCmm subapp all level debug3
swlog appid ipmsNi subapp all level debug3
An example output of a single IGMPv2 Membeship Request (IGMP receiver is located is connected to port
1/1/48 and the sender to port 2/1/1):
-> show log swlog | grep -E "ipmsCmm|ipmsNi"
<snap> swlogd: ipmsCmm msg debug1(6) ip/6 recv len 164
<snap> swlogd: ipmsNi cap debug1(6) pd_recv/4 src 00-00-00-00-00-01 vlan 1 stack 0 modid 0 port
48 vpn 47 vp 0 cpu 1 flood 1 pd_client 0
<snap> swlogd: ipmsNi cap debug1(6) igmp type x16 vlan 1 stack 0 port 1/1/48 group 239.0.0.1 host
192.168.1.1 sa 00-00-00-00-00-01
<snap> swlogd: ipmsNi msg debug1(6) mcm report vlan 1 stack 0 port 1/1/48 vp 0 host 192.168.1.1
sa 00-00-00-00-00-01 modid 0 devport 48
<snap> swlogd: ipmsCmm msg debug1(6) cni recv len 76
<snap> swlogd: ipmsCmm msg debug1(6) cni report vlan 1 stack 0 port 1/1/48 svp 0 host 192.168.1.1
sa 00-00-00-00-00-01 modid 0 devport 48

Table of Contents

Other manuals for Alcatel-Lucent OmniSwitch 10K

Related product manuals