Alcatel-Lucent OmniSwitch 10K - Troubleshooting in the Maintenance Shell

OmniSwitch OS6860/OS6900/OS10K Troubleshooting Guide Part No.032996-00 Rev.A
AOS Release 7.X and 8.X January 2015
Alcatel-Lucent Page 110 of 148
-> debug ip multicast flow
Total 1 Flows
indexes inuse 1 max 8189
Group Address/ Host Address/ Next Address VLAN/ Port Index Chas_ID
Dest Address Orig Address
Next
---------------+---------------+---------------+-----+---------+------+-------
239.0.0.1 10.0.0.1 0.0.0.0 1 2/1/1 3 2
0.0.0.0 0.0.0.0
1
An example output of "debug ip multicat channel":
-> debug ip multicast channel
Total 1 Channels
Group Address/ VLAN Mode Count Life V V1 V2
Source Address
---------------+-----+--------+------+-----+---+-----+-----
239.0.0.1 1 exclude 6 194 2 0 194
Display IP interface configuration related to multicast:
-> debug ip multicast interface
Total 3 Interfaces
IfIndex Host Address Mac Address VLAN VRF Other Query Count
---------+---------------+-------------------+-----+----+------+------+------
13600001 192.168.10.253 00-00-00-00-00-00 10 0 0 0 0
13600002 192.168.100.254 e8-e7-32-ab-17-bd 100 0 0 0 0
13604125 127.0.0.1 00-00-00-00-00-00 0 0 0 0 0
A more detailed version of "show ip muticast vlan":
-> debug ip multicast vlan 1
Routing = disabled,
Turning = disabled,
Elected = false,
Group Membership Interval (seconds) = 260,
Querier Interval (seconds) = 255,
Startup Query Interval (seconds) = 31,
Last Member Query Time (seconds) = 2,
Unsolicited Report Time (seconds) = 1,
Cvg Query Response Interval (tenths of seconds) = 25,
Cvg Startup Query Interval (seconds) = 7,
IGMPv1 Querier Present (seconds) = 0,
IGMPv2 Querier Present (seconds) = 241
Display IP multicast statistics:
-> debug ip multicast stats
Global RX Statistics
V1 Reports = 0 | V1 Queries = 0
V2 Reports = 19 | V2 Queries = 9
V2 Leaves = 3 |
V3 Reports = 2 | V3 Queries = 0
PIM Hellos = 0 | DVMRP Probes = 0
Global TX Statistics
V1 Reports = 0 | V1 Queries = 0
V2 Reports = 6 | V2 Queries = 27
V2 Leaves = 1 |
V3 Reports = 0 | V3 Queries = 0
14.4. Troubleshooting in the Maintenance Shell
Warning:
Maintenance Shell commands should only be used by Alcatel-Lucent personnel or under the
direction of Alcatel-Lucent. Misuse or failure to follow procedures that use Maintenance Shell
commands in this guide correctly can cause lengthy network down time and/or permanent damage
to hardware.
Verify the software forwarding limit:
TOR #-> debug $(pidof ipmscmm) 'p ipms::bcm_max'