OmniSwitch OS6860/OS6900/OS10K Troubleshooting Guide Part No.032996-00 Rev.A
AOS Release 7.X and 8.X January 2015
Alcatel-Lucent Page 128 of 148
2 30000 0 Searching Low ON *
3 30000 0 Searching Low ON *
4 30000 0 Searching Low ON *
5 30000 0 Searching Low ON *
6 30000 0 Searching Low ON *
7 30000 0 Searching Low ON *
8 30000 0 Searching Low ON *
9 30000 0 Searching Low ON *
…
ChassisId 1 Slot 1 Max Watts 780
780 Watts Total Power Budget Used
0 Watts Total Power Budget Available
1 Power Supply Available
BPS power: Not Available
Definition of terms:
"ChassisId 1 Slot 1 Max Watts" refers to the Maximum watts allocated to the corresponding chassis and slot.
"Watts Total Power Budget Used" refers to the Power Budget for the PoE ports.
"Watts Total Power Budget Available" refers to the Amount of power budget remaining that can be allocated
for additional switch functions.
"Power Supply Available" refers to the number of Power Supply.
"BPS power:" refers to the availability of the Redundant Power Supply.
Additional PoE features/commands:
1. Capacitor-detection
This feature is disabled by default. It is enabled when there are legacy devices (such as IP phones) attached to
the corresponding slot. Note that this feature is not compatible with IEEE specifications.
-> show lanpower slot <chassis/slot> capacitor-detection
Below is an example:
-> show lanpower slot 1/1 capacitor-detection
Capacitor Detection disabled on ChassisId 1 Slot 1
2. Class-detection
This feature is disabled by default. When class detection is enabled, attached devices will automatically be
limited to their class power, regardless of port power configuration.
-> show lanpower slot <chassis/slot> class-detection
Below is an example:
-> show lanpower slot 1/1 class-detection
Class Detection disabled on ChassisId 1 Slot 1
3. Priority-disconnect
This feature is enabled by default. Priority disconnect is used by the system software in determining whether
an incoming PD will be granted or denied power when there are too few watts remaining in the PoE power
budget for an additional device.
-> show lanpower slot <chassis/slot> priority-disconnect
To Next Page
Loading...
