Alcatel-Lucent OmniSwitch 10K - SPB Debug Information

OmniSwitch OS6860/OS6900/OS10K Troubleshooting Guide Part No.032996-00 Rev.A
AOS Release 7.X and 8.X January 2015
Alcatel-Lucent Page 138 of 148
sap:2/1/26:0 Up Up N Y:x 2/1/26 -
sdp:32787:3000* Up Up Y e8e7.32b3.365d:4003 2/1/27 OS6860
Total Ports: 2
To view configuration information for a specific SAP, use the show service spb sap command.
For example:
-> show service spb 3000 sap port 2/1/26:0
SAP Detailed Info
SAP Id : 2/1/26:0, Description : ,
Admin Status : Up, Oper Status : Up,
Stats Status : No, Vlan Translation : No,
Service Type : SPB, Allocation Type : Static,
Trusted : Yes, Priority : 0,
Ingress Pkts : 0, Ingress Bytes : 0,
Egress Pkts : 0, Egress Bytes : 0,
Mgmt Change : 03/07/2014 05:47:38, Status Change : 03/07/2014 05:50:50
21.2. SPB debug information
To display the debug information for the virtual ports associated with the SPB service. A virtual port
represents a Service Access Point (SAP) or a Service Distribution Point (SDP) that is associated with the
specified SPB service. In addition to the virtual port configuration, the command show service spb debug-
info also provides the status and additional configuration information for the SPB service.
-> show service spb 3000 debug-info
Legend: (*) dyn unicast object (+) remote mcast object (#) local mcast object
SPB Service 3000 Debug Info
Admin : Up, Oper : Up, Stats : N, Mtu : 9194, VlanXlation : N,
ISID : 13000, BVlan : 4003, MCast-Mode : Headend, Tx/Rx : 0/0,
VFI : 2, McIdx : 8190, StatsHandle: 0
Sap Trusted:Priority/ Sap Description /
Stats /
Identifier Adm Oper Stats Sdp SystemId:BVlan Intf Sdp SystemName
VP L2 McIdx
----------------------+----+----+-----+--------------------+--------+----------------------------
----+------+---------
sap:2/1/26:0 Up Up N Y:x 2/1/26 -
3 0
sdp:32787:3000* Up Up Y e8e7.32b3.365d:4003 2/1/27 OS6860
4 1
Total Ports: 2
The command show service spb counters displays the traffic statistics for the specified SPB service and
associated virtual ports. Use the sap parameter options with this command to display statistics for a specific
SAP ID. A SAP ID is comprised of an access port (slot/port or agg_id) and an encapsulation value (:0, :all,
:qtag, or :outer_qtag.inner_qtag) that is used to identify the type of customer traffic to map to the associated
service.
-> show service spb 3000 counters
Legend: * denotes a dynamic object
Identifier Ing Pkts Ing Byte Count Egr Pkts Egr Byte Count
----------------------+----------+---------------+----------+----------------
sdp:32787:3000* 29 2722 545 47102
Total Ports: 1
The command show service l2profile display the Layer 2 profile configuration information for the bridge.
This type of profile is applied to access (customer-facing) ports and specifies how to process Layer 2 protocol
frames ingressing on such ports.
-> show service l2profile