OmniSwitch OS6860/OS6900/OS10K Troubleshooting Guide Part No.032996-00 Rev.A
AOS Release 7.X and 8.X January 2015
Alcatel-Lucent Page 65 of 148
Examples provided in this document are taken from an OmniSwitch 6900 running 7.3.2.355.R01 with 26 ports
which is a one NI (Network Interface) version. NI consists of a switching ASIC and physical ports.
Policy Condition and Action Guidelines
List of the Policy Conditions and Actions Available
Layer 1 Conditions
Source / destination port
Source / destination port group
Layer 2 Conditions
Source MAC / MAC group
Destination MAC / MAC group
802.1p
Ethertype
Source VLAN
Destination VLAN (multicast rules only)
Outer VLAN
Inner VLAN
Layer 3 Conditions
IP Protocol
Source / destination IP
Source / destination network group
ToS
DSCP
ICMP code/type
IPV6 Destination IP, Traffic, Next Header, Flow Label
Multicast IP / Network Group
Layer 4 Conditions
Source / destination TCP/UDP port
Destination
Service
Service group
ICMP type
TCP Flags
IP Multicast
For IGMP ACLs QoS Actions
ACL Drop
Priority, specify the egress queue (0-7)
Specify the maximum queue depth
802.1p stamping and mapping
ToS stamping and mapping
DSCP stamping and mapping
Permanent gateway (Policy Based Routing)
Maximum Bandwidth
Port Redirection
Port Disable
Policy Condition Combination Matrix
Source VLAN and
802.1p only
Source VLAN and
802.1p only
Policy Action Combination Matrix