Alcatel-Lucent OmniSwitch 10K - Page 88

OmniSwitch OS6860/OS6900/OS10K Troubleshooting Guide Part No.032996-00 Rev.A
AOS Release 7.X and 8.X January 2015
Alcatel-Lucent Page 88 of 148
Exit Overflow Interval = 0,
# of SPF calculations done = 3,
# of Incr SPF calculations done = 0,
# of Init State Nbrs = 0,
# of 2-Way State Nbrs = 0,
# of Exchange State Nbrs = 0,
# of Full State Nbrs = 1,
# of attached areas = 2,
# of Active areas = 1,
# of Transit areas = 0,
# of attached NSSAs = 0,
Default Route Origination = none,
Default Route Metric-Type/Metric = type2 / 1,
BFD Status = Disabled
Displays information on OSPF non-virtual neighbor routers:
-> show ip ospf neighbor
IP Address Area Id Router Id Vlan State Type
----------------+----------------+----------------+------+-------+--------
192.168.1.2 0.0.0.0 192.168.1.2 1 Full Dynamic
Displays information on OSPF non-virtual neighbor routers (detailed output):
-> show ip ospf neighbor 192.168.1.2
Neighbor's IP Address = 192.168.1.2,
Neighbor's Router Id = 192.168.1.2,
Neighbor's Area Id = 0.0.0.0,
Neighbor's DR Address = 192.168.1.2,
Neighbor's BDR Address = 192.168.1.1,
Neighbor's Priority/Eligibility = 1,
Neighbor's State = Full,
Hello Suppressed ? = No,
Neighbor's type = Dynamic,
# of State Events = 6,
Mode = Slave,
MD5 Sequence Number = 0,
Time since Last Hello = 4 sec,
# of Outstanding LS Requests = 0,
# of Outstanding LS Acknowledgements = 0,
# of Outstanding LS Retransmissions = 0,
Restart Helper Status = notHelping,
Restart Age (in seconds) = 0 sec,
Last Restart Helper Exit Reason = None
Displays OSPF interface information:
-> show ip ospf interface
Interface DR Backup DR Admin Oper BFD
Name Address Address Status Status State Status
---------------------+----------------+----------------+--------+------+-------+-----------
vlan1 192.168.1.2 192.168.1.1 enabled up BDR disabled
Displays OSPF interface information (detailed output):
-> show ip ospf interface vlan1
Interface IP Name = vlan1,
VLAN Id = 1,
Interface IP Address = 192.168.1.1,
Interface IP Mask = 255.255.255.0,
Admin Status = Enabled,
Operational Status = Up,
OSPF Interface State = BDR,
Interface Type = Broadcast,
Area Id = 0.0.0.0,
Designated Router IP Address = 192.168.1.2,
Designated Router RouterId = 192.168.1.2,
Backup Designated Router IP Address = 192.168.1.1,
Backup Designated Router RouterId = 192.168.1.1,
MTU (bytes) = 1500,
Metric Cost = 1,