OmniSwitch OS6860/OS6900/OS10K Troubleshooting Guide Part No.032996-00 Rev.A
AOS Release 7.X and 8.X January 2015
Alcatel-Lucent Page 89 of 148
Priority = 1,
Hello Interval (seconds) = 10,
Transit Delay (seconds) = 1,
Retrans Interval (seconds) = 5,
Dead Interval (seconds) = 40,
Poll Interval (seconds) = 120,
Link Type = Broadcast,
Authentication Type = none,
# of Events = 26,
# of Init State Neighbors = 0,
# of 2-Way State Neighbors = 0,
# of Exchange State Neighbors = 0,
# of Full State Neighbors = 1,
BFD status = Disabled,
DR-Only Option for BFD = Disabled
Displays all OSPF areas:
-> show ip ospf area
Area Id AdminStatus Type OperStatus
---------------+-------------+-------------+------------
0.0.0.0 enabled normal up
Displays a specified OSPF area information:
-> show ip ospf area 0.0.0.0
Area Identifier = 0.0.0.0,
Admin Status = Enabled,
Operational Status = Up,
Area Type = normal,
Area Summary = Enabled,
Time since last SPF Run = 00h:09m:12s,
# of Area Border Routers known = 0,
# of AS Border Routers known = 0,
# of Active Virtual Links = 0,
# of LSAs in area = 3,
# of SPF Calculations done = 3,
# of Incremental SPF Calculations done = 0,
# of Neighbors in Init State = 0,
# of Neighbors in 2-Way State = 0,
# of Neighbors in Exchange State = 0,
# of Neighbors in Full State = 1,
# of Interfaces attached = 2,
Attached Interfaces = vlan1, vlan2
Displays LSAs in the Link State Database associated with each area:
-> show ip ospf lsdb
Area Id Type LS Id Orig Router-Id SeqNo Age
----------------+-------+----------------+----------------+------------+-----
0.0.0.0 rtr 192.168.1.1 192.168.1.1 0x80000003 584
0.0.0.0 rtr 192.168.1.2 192.168.1.2 0x80000004 581
0.0.0.0 net 192.168.1.2 192.168.1.2 0x80000002 580
12.5. Advanced troubleshooting
Enabling SWLOGs logs per VRF
The applicable protocols have switch logging application names with an appended number that indicates the
VRF identifier ("vrfid") of the VRF in which the protocol is running. The default VRF always corresponds to
"vrfid" zero. So the switch logging application-name for ospf in the default VRF is "ospf_0". To figure out
which "vrfid" corresponds to a given non-default VRF name, one must examine the "ps" output in the su shell.
An example output from a switch that is running OSPF in three VRFs:
-> show vrf
Virtual Routers Profile Protocols
--------------------+-------+-------------------
To Next Page
Loading...
