Mounting OS6250 Switches Assembling OS6250 Switches
OmniSwitch 6250 Series Hardware Users Guide September 2009 page 3-5
Preliminary
9/28/09
Assembling OS6250 Switches
Assembly Guidelines
Depending on the model, power supplies, and mounting requirements, the OS6250 can be mounted in a
variety of ways.
• Power supply trays can be mounted on the side or back of the chassis or both.
• Two chassis can be mounted side-by-side for rack mounting.
• Power supply trays can be mounted to the rear of the chassis.
Attaching the Power Supply Tray on Side of Chassis
When rack mounting a single switch, the power supply tray can be positioned at the side of the unit assem-
bly. This allows the chassis and power supply tray assembly to span the full width of the rack.
If two external power supplies are to be used an additional power supply tray must be mounted immedi-
ately behind the switch chassis. Refer to the table on page 3-4 for additional power supply requirements.
Power supply tray side installation
A chassis and power supply tray can be assembled side-by-side to fit into a standard 19-inch rack mount
as show in the figure below.
Fully Assembled Chassis and Power Supply Tray
Front center mounting brackets.
Rear center mounting bracket.
To Next Page
Loading...
