Port Mapping Commands
page 28-6 OmniSwitch 6250 CLI Reference Guide November 2009
port mapping
Configures the direction of a port mapping session.
port mapping port_mapping_sessionid {unidirectional | bidirectional}
Syntax Definitions
port_mapping_sessionid The port mapping session ID. Valid range is 1 to 8.
unidirectional Specifies unidirectional port mapping.
bidirectional Specifies bidirectional port mapping.
Defaults
Platform Supported
OmniSwitch 6250
Usage Guidelines
• In the bidirectional mode, the network ports of a session cannot communicate with each other. Also,
the network ports of that session cannot be a part of a network port set of another session.
• In the unidirectional mode, the network ports of a session can communicate with each other. Also, the
network ports of that session can be part of a network port set of another session, which is also in the
unidirectional mode.
• To change the direction of an active session with network ports, delete the network ports of the session,
change the direction, and recreate the network ports.
Examples
-> port mapping 5 unidirectional
-> port mapping 6 bidirectional
Release History
Release 6.6.1; command was introduced.
parameter default
unidirectional | bidirectional bidirectional
To Next Page
Loading...
