IP Commands
page 29-8 OmniSwitch 6250 CLI Reference Guide November 2009
ip router router-id
Configures the router ID for the router. By default, the router primary address of the router is used as the
router ID. However, if a primary address has not been explicitly configured, the router ID defaults to the
address of the first IP interface that becomes operational.
ip router router-id ip_address
Syntax Definitions
ip_address 32-bit IP address.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• The router ID can be any 32-bit number.
• If the router ID is not a valid IP unicast host address, the BGP identifier is derived from the router
primary address.
• It is recommended that the router ID be explicitly configured on dual CMM chassis or stacked routers.
Examples
-> ip router router-id 172.22.2.115
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
alaDcrTmConfig
alaDrcTmIpRouterId
ip router primary-address Configures the router primary IP address.
To Next Page
Loading...
