IP Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 29-13
ip default-ttl
Configures the Time To Live value (TTL) for IP packets. The TTL value is the maximum number of hops
an IP packet will travel before being discarded.
ip default-ttl hops
Syntax Definitions
hops TTL value, in hops. Valid range is 1–255.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
This value represents the default value inserted into the TTL field of the IP header for datagrams originat-
ing from this switch whenever a TTL value is not supplied by the transport layer protocol.
Examples
-> ip default-ttl 30
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
IpDefaultTTL
parameter default
hops 64
show ip config Displays IP configuration parameters.
To Next Page
Loading...
