Alcatel-Lucent OmniSwitch 6250 - Page 1130

IP Commands
page 29-82 OmniSwitch 6250 CLI Reference Guide November 2009
-> show ip interface Marketing
Interface Name = Marketing
SNMP Interface Index = 13600007,
IP Address = 172.16.105.10,
Subnet Mask = 255.255.0.0,
Broadcast Address = 172.16.255.255,
Device = vlan 200,
Encapsulation = eth2,
Forwarding = disabled,
Administrative State = enabled,
Operational State = down,
Operational State Reason = device-down,
Router MAC = 00:d0:95:6a:f4:5c,
Local Proxy ARP = disabled,
Maximum Transfer Unit = 1500,
Primary (config/actual) = no/yes
Subnet Mask IP subnet mask for the interface IP address. Configured through the ip
interface command.
Status Interface status:
• UP—Interface is ready to pass packets.
• DOWN—Interface is down.
Forward Indicates whether or not the interface is actively forwarding packets
(YES or NO).
Device The type of device bound to the interface:
• unbound—No device is bound to the interface.
• vlan—The VLAN ID that is bound to the interface.
• Loopback—A loopback interface is configured for testing.
Configured through the ip interface command.
output definitions
SNMP Interface Index Interface index.
IP Address IP address associated with the interface. Configured through the
ip interface command.
Subnet Mask IP subnet mask for the interface. Configured through the ip interface
command.
Broadcast Address Broadcast address for the interface.
Device The type of device bound to the interface:
• unbound—No device is bound to the interface.
• vlan—The VLAN ID that is bound to the interface.
• Loopback—A loopback interface is configured for testing.
Configured through the ip interface command.
Encapsulation Displays the IP router encapsulation (eth2 or snap) that the interface
will use when routing packets. Configured through the ip interface
command.
Forwarding Indicates whether or not IP forwarding is active for the interface
(enabled or disabled). Configured through the ip interface command.
Administrative State Administrative state of the IP interface (enabled or disabled), which is
independent of the state of the underlying device. Configured through
the ip interface command.
output definitions