IP Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 29-83
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
alaIpInterfaceTable
alaIpInterfaceName
alaIpInterfaceAddress
alaIpInterfaceMask
alaIpInterfaceAdminState
alaIpInterfaceDeviceType
alaIpInterfaceVlanID
alaIpInterfaceIpForward
alaIpInterfaceEncap
alaIpInterfaceLocalProxyArp
alaIpInterfacePrimCfg
alaIpInterfaceOperState
alaIpInterfaceOperReason
alaIpInterfaceRouterMac
alaIpInterfaceBcastAddr
alaIpInterfacePrimAct
alaIpInterfaceMtu
Operational State Indicates whether or not the interface is active (up or down).
Operation State Reason Indicates why the operational state of the interface is down:
• unbound—No device is bound to the interface.
• device-down—Device bound to the interface is down.
• admin-down—The admin state of the interface is down.
• no-such-device—Device does not exist.
• no-router-mac—No MAC address available for the interface.
Note that Operational State Reason field is only included in the dis-
play output when the operational state of the interface is down.
Router MAC Switch MAC address assigned to the interface. Note that each interface
assigned to the same VLAN will share the same switch MAC address.
Local Proxy ARP Indicates whether or not Local Proxy ARP is active for the interface
(enabled or disabled). Configured through the ip interface command.
Maximum Transfer Unit The Maximum Transmission Unit size set for the interface. Configured
through the ip interface command.
Primary (config/actual) Indicates if the interface is the configured and/or actual primary inter-
face for the device (VLAN, EMP, Loopback). If the actual status is set
to yes and the config status is set to no, the interface is the default inter-
face for the VLAN. Configured through the ip interface command.
ip interface Configures an IP interface to enable IP routing on a VLAN. With-
out an IP interface, traffic is bridged within the VLAN or across
connections to the same VLAN on other switches.
show icmp statistics Displays ICMP statistics and errors.
output definitions (continued)
To Next Page
Loading...
