IPv6 Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 30-45
Examples
-> show ipv6 router database
Legend: + indicates routes in use
Total IPRM IPv6 routes: 5
Destination/Prefix Gateway Address Interface Protocol Metric
-------------------+-------------------------+-----------------+---------+-------
195:35::/64 fe80::2d0:95ff:fe12:f470 v6if-to-eagle RIP 2
212:95:5::/64 fe80::2d0:95ff:fe12:f470 smbif-5 Local 1
Inactive Static Routes:
VLAN Destination/Prefix Gateway Address Metric
-----+-------------------+-------------------------+-------
1510 212:95:5::/64 fe80::2d0:95ff:fe6a:f458 1
Release History
Release 6.6.1; command was introduced.
Related Commands
output definitions
Destination/Prefix IPv6 destination address and prefix.
Gateway Address IPv6 address of the gateway used to reach the destination network.
Interface The IPv6 interface name or loopback.
Protocol Protocol by which this IPv6 address was learned (LOCAL, STATIC,
RIP).
Metric RIP metric or cost (hop count) for the route. Indicates a priority for the
route. The lower the metric value, the higher the priority.
VLAN The VLAN on which the route was learned, not forwarded. Note that
N/A appears in this field for static routes as they are not learned on a
VLAN.
show ipv6 routes Displays the IPv6 Forwarding Table.
To Next Page
Loading...
