Alcatel-Lucent OmniSwitch 6250 - Ipv6 Rip Interface Recv-Status

IPv6 Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 30-77
ipv6 rip interface recv-status
Configures IPv6 RIPng interface “Receive” status. When this status is set to "enable", packets can be
received on this interface. When it is set to "disable", packets will not be received on this interface.
ipv6 rip interface if_name recv-status {enable | disable}
Syntax Definitions
if_name IPv6 interface name.
enable | disable Interface “Receive” status.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
RIPng must be loaded (ipv6 load rip) and enabled (ipv6 rip status)on the switch to send or receive pack-
ets on the interface.
Examples
-> ipv6 rip interface Test_Lab recv-status disable
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
alaRipngInterfaceTable
alaRipngInterfaceRecvStatus
parameter default
enable | disable enable
ipv6 redist Loads RIPng into memory.
ipv6 rip status Enables/disables RIPng on the switch.
ipv6 rip interface send-status Configures IPv6 RIPng interface “Send” status.