IPv6 Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 30-79
ipv6 rip interface horizon
Configures the routing loop prevention mechanisms.
ipv6 rip interface if_name horizon {none | split-only | poison}
Syntax Definitions
if_name IPv6 interface name.
none | split-only | poison none - Disables loop prevention mechanisms.
split-only - Enables split-horizon, without poison-reverse.
poison - Enables split-horizon with poison-reverse.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• If set to none the route is not sent back to the peer.
• If set to split-only, the route received from the peer is sent back with an increased metric.
• If set to poison the route received from the peer is sent back with an “infinity” metric.
Examples
-> ipv6 rip interface Test_Lab none
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
alaRipngInterfaceTable
alaRipngInterfaceHorizon
parameter default
none | split-only | poison poison
show ipv6 rip interface Displays information for all or specified RIPng interfaces.
show ipv6 rip routes Displays all or a specific set of routes in the RIPng Routing Table.
To Next Page
Loading...
