IPv6 Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 30-83
Release History
Release 6.6.1; command was introduced.
Related Commands
Packets Sent Number of packets sent by the interface.
Metric RIPng metric (cost) configured for the interface.
IPv6 interface index IPv6 interface index number.
Interface status Interface status (Active/Inactive).
Next update Seconds remaining until the next update on this interface.
Horizon mode Interface Horizon Mode (routing loop prevention mechanisms). Dis-
played modes are none/split-only/poison-reverse.
MTU size Maximum transmission size for RIPng packets on the interface.
Send status Interface “Send” status. When this status is set to "enable", packets can
be sent from this interface. When it is set to "disable", packets will not
be sent from this interface.
Receive status Interface “Receive” status. When this status is set to "enable", packets
can be received by this interface. When it is set to "disable", packets
cannot be received by this interface.
Packets received Number of packets received by the interface.
Packets sent Number of packets sent by the interface.
ipv6 rip interface IPv6 interface name.
ipv6 rip status Enables or disables RIPng routing on the switch.
ipv6 rip interface recv-status Configures the interface “Receive” status. When this status is set to
"enable", packets can be received by this interface. When it is set to
"disable", packets cannot be received by this interface.
ipv6 rip interface send-status Configures the interface “Send” status. When this status is set to
"enable", packets can be sent from this interface. When it is set to
"disable", packets will not be sent from this interface.
ipv6 rip interface metric Configures the RIPng metric (cost) for the interface.
ipv6 rip interface horizon Configures the interface Horizon Mode (routing loop prevention
mechanisms).
show ipv6 rip Displays RIPng status and general configuration parameters (e.g.,
force holddown timer).
output definitions (continued)
To Next Page
Loading...
