IPv6 Commands
page 30-86 OmniSwitch 6250 CLI Reference Guide November 2009
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
alaRipngPeerTable
alaRipngPeerEntry
alaRipngPeerAddress
alaRipngPeerIndex
alaRipngPeerLastUpdate
alaRipngPeerNumUpdates
alaRipngPeerBadPackets
alaRipngPeerNumRoutes
alaRipngPeerBadRoutes
output definitions
Address IPv6 address of the peer.
Seen on Interface Interface used to reach the peer.
Packets Recvd Number of packets received from the peer.
Last Update Number of seconds since the last update was received from the peer.
Peer address Peer IPv6 address.
Received packets Number of packets received from the peer.
Received bad packets Number of bad packets received from the peer.
Received routes Number of RIPng routes received from the peer.
Received bad routes Number of bad RIPng routes received from the peer.
show ipv6 rip interface Displays all or specified RIPng interface status.
show ipv6 rip routes Displays all or a specific set of routes in RIPng Routing Table.
To Next Page
Loading...
