RDP Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 31-13
ip router-discovery interface preference-level
Configures the preference level for each IP address advertised on the specified RDP interface. The end
host selects the address with the highest preference level to use as its default router, if the host is not
already redirected or configured to use another default router for a particular destination.
ip router-discovery interface name preference-level level
Syntax Definitions
name The IP interface name that was defined at the time the IP interface was
configured.
level Any positive, integer value.The higher the value, the higher the prece-
dence.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• The RDP interface preference level value is not active unless RDP is enabled on the switch and the
specified interface is also enabled.
• Set the preference level higher to encourage the use of an advertised router IP address.
• Set the preference level lower to discourage the use of an advertised router IP address.
• The preference level of an advertised router IP address is compared only to the preference levels of
other addresses on the same subnet.
Examples
-> ip router-discovery interface Marketing preference-level 10
-> ip router-discovery interface Accounting preference-level 50
Release History
Release 6.6.1; command was introduced.
parameter default
level 0
To Next Page
Loading...
