RIP Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 33-29
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
alaProtocolRip
alaRipProtoStatus
alaRip2IfConfAugTable
alaRip2IfConfName
alaRip2IfRecvPkts
alaRip2IfIpConfStatus
rip2IfConfTable
rip2IfConfAddress
rip2IfConfAuthType
rip2IfConfAuthKey
rip2IfConfSend
rip2IfConfReceive
rip2IfConfDefaultMetric
rip2IfStatTable
rip2IfStatRcvBadPackets
rip2IfStatRcvBadRoutes
rip2IfStatSentUpdates
Interface Config AuthKey
Length
The authentication key length used for the RIP interface.
Interface Config Send-Version Interface send option (none, v1, v2, and v1 compatible). Default is v2.
Interface Config Receive-Ver-
sion
Interface receive option (none, v1, v2, and both). Default is both.
Interface Config Default Met-
ric
Default redistribution metric. Default is 1.
Received Packets Number of packets received on the interface.
Received Bad Packets Number of bad packets received and discarded. Normally this value is
zero (0).
Received Bad Routes Number of bad routes received and discarded. Normally this value is
zero (0).
Sent Updates Number of RIP routing table updates sent.
ip rip interface Enables/disables RIP for a specific interface.
output definitions (continued)
To Next Page
Loading...
