Port Mirroring and Monitoring Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 34-7
port monitoring source
Configures a port monitoring session.
port monitoring port_monitor_sessionid source slot/port
[{no file | file filename [size filesize] | [overwrite {on | off}]}]
[inport | outport | bidirectional] [timeout seconds] [enable | disable]
Syntax Definitions
port_monitor_sessionid Monitoring session identifier.
slot/port Enter the slot number for the module and the physical port number on
that module (e.g., 3/1 specifies port 1 on slot 3).
file filename Specifies a file name for the monitoring session (e.g., /flash/port2).
filesize Specifies the size of the file in 16K (16384) byte increments. For exam-
ple, a value of 3 would specify a size of 49152 bytes. The file size can
be up to 160 K (163840 bytes).
no file Specifies that no file will be created for the monitoring session.
on Specifies that any existing port monitoring file in flash memory will be
overwritten if the total data exceeds the specified file size.
off Specifies that any existing port monitoring file in flash memory will not
be overwritten if the total data exceeds the specified file size.
inport Specifies incoming unidirectional port monitoring.
outport Specifies outgoing unidirectional port monitoring.
seconds Specifies the number of seconds after which the session is disabled. The
range is 0–2147483647 where 0 is forever.
enable Enables the port monitoring status.
disable Disables the port monitoring status.
Defaults
Platforms Supported
OmniSwitch 6250
parameter default
filesize 1
on | off on
bidirectional | inport | outport bidirectional
seconds 0
enable | disable disable
To Next Page
Loading...
