RMON Commands
page 35-4 OmniSwitch 6250 CLI Reference Guide November 2009
show rmon probes
Displays a list of RMON probes or a single RMON probe.
show rmon probes [stats | history | alarm] [entry-number]
Syntax Definitions
stats Ethernet Statistics Table probe entries.
history History Control Table probe entries.
alarm Alarm Table probe entries.
entry-number The entry number in the list of probes (optional).
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• To display a list of current probes, omit the entry-number from the command line.
• To display statistics for a particular probe, include the probe’s entry-number in the command line.
• The show rmon probes command displays the following information: Entry number, Slot/Port, Flavor
(whether the probe type is Ethernet, History or Alarm), Status (Active or Inactive), Duration (time
since the last change in status, in hours/minutes) and System Resources (the amount of memory allo-
cated to this probe).
• The show rmon probes entry-number command displays the following information: Probe’s Owner
(probe type and location), Slot/Port, Entry number, Flavor (whether the probe type is Ethernet, History
or Alarm), Status (Active or Inactive), Time since the last change in status (hours/minutes), and System
Resources (the amount of memory allocated to this probe). Displayed statistics may vary, depending on
whether the probe type is Ethernet, History or Alarm.
Examples
-> show rmon probes stats
Entry Slot/Port Flavor Status Duration System Resources
-------+-----------+-----------+----------+---------------+---------------------
4001 4/1 Ethernet Active 00:25:00 275 bytes
4008 4/8 Ethernet Active 00:25:00 275 bytes
4005 4/5 Ethernet Active 00:25:00 275 bytes
To Next Page
Loading...
