sFlow Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 37-15
show sflow poller
Displays the sflow poller table.
show sflow poller [num]
Syntax Definitions
num Specifies the instance id.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
N/A
Examples
-> show sflow poller
Instance Interface Receiver Interval
-------------------------------------------
1 2/ 6 1 30
1 2/ 7 1 30
1 2/ 8 1 30
1 2/ 9 1 30
1 2/10 1 30
Release History
Release 6.6.1; command was introduced.
output definitions
Instance Instance for the counter poller.
Interface Interface used for the counter poller.
Receiver Receiver associated with the counter poller.
Interval The maximum number of seconds between successive samples of the
counters associated with the data source.
To Next Page
Loading...
